Design Features:

  • Quick tool change
  • Servo Regulators (air) (heat/form/eject)
  • Swing away preheater
  • Servo driven platen
  • Six point toggle system with oversized roller bearings
  • High speed forming system
  • Multi-zone contact heating system
  • Electric preheater
  • Microprocessor-based control systems (PLC)
  • Computerized DC drive sheet transport with photo scanning capabilities for pre-printed materials
  • Antistatic unit
  • Low maintenance

Optional Equipment:

  • Photoscanning registration unit for pre-printed material
  • Spare heater platen assembly (for quick tool changes)

GN Tooling:

  • Tool design, development and prototyping
  • Complete production tooling


Material Thickness Range 0.15mm - 1.00mm (0.006"-0.040")
Knife Length 11500mm (453") maximum for APET - 16510mm (650") maximum for other thermoformable materials
Forming Area 1143mm x 813mm (45" x 32 ") maximum
Depth of Draw 125mm (5") maximum
Sheet Width 1194mm (47") maximum
Material Roll Diameter 1000mm (39") maximum
Cycles per Minute 20 maximum
Power Supply 380/415/440V 50/60Hz 24 Volt DC Control Voltage
Power Consumption 20 Kilowatts/hr (Average)
Air Pressure 6.8 bar (100 PSI) minimum
Air Consumption 1900 Litres/min (70 CFM)
Cooling Water Consumption 14 Litres/min @ 15C - 20C (3 gal/min @ 58F - 68F)
Machine Dimensions (l x w x h) 4050mm x 2300mm x 2800mm (160" x 91" x 110")
Machine Weight 11,400 kg (25,132 lbs)


D Series Brochure

Back to Equipment