GN760
Description
The GN760 is a Plug-Assist Thermoformer incorporating GN Thermoforming Technology achieved through continuous research and development.
Main Features:
- In-mould cutting
- Unique plug drive with twin servo motors
- Radiant heat system with 60 zones
- Robotic handling system
- Advance diagnostics
- Powerful GN toggle system
- Energy conservation with power regeneration circuitry
Optional Equipment:
- Material pre-heating system
- Motorized material unwind unit (required when no pre-heater is used)
GN Tooling:
- Cost effective tooling is designed, manufactured and production tested at our facility
Specifications
| Forming Area | 762mm x 534mm (30" x 21") maximum |
| Knife Length (maximum) | 8500mm (335") for APET / 9525mm (375") for other thermoformable materials |
| Depth of Draw | 125mm (4.92") below sheet line
15mm (0.59") above sheet line |
| Running Power Consumption | 28 Kilowatts/hr (Approximate) |
| Air Consumption (Approximate) | 4400 nL/min @ 6.2 bar (155 SCFM @ 90 PSI) |
| Machine Dimensions (l x w x h) | 10400mm x 3650mm x 2930mm (410" x 144 " x 116 ") |
| Machine Weight | 7300 kgs (16100 lbs) |
| Material Thickness Range | 0.25mm - 1.50mm (0.010"-0.060") |
| Air Pressure | 6.2 bar (90 PSI) minimum / 9.6 bar (140 PSI) maximum |
| Cooling Water Consumption | 65 - 150 litres/min (17 - 40 gallons/min) |
| Sheet Width | 815mm (32") maximum |
| Material Roll Diameter | 1000mm (39") |
| Main Supply Voltage | 3 Phase + N + PE, 50-60 Hz (380-480V) |
